There are many products available to add more power to your Chrysler, but most are very expensive and require a large amount of time and work to install. The Chrysler throttle body spacer is one of the exceptions. It is made of aluminum and is installed between the cold air intake and the throttle body, often in less than an hour. All of the hardware and gaskets the Chrysler throttle body spacer requires are included with the unit. Simply disconnect the cold air intake and remove the old gasket from the throttle body. Install the Chrysler throttle body spacer with the appropriate gasket on each side, and bolt the cold air intake into its new position. The main job of the Chrysler throttle body spacer is to optimize the flow of air into the engine. It does this by inducing a spiral flow pattern in the incoming air. This makes the air travel faster, and it makes the air much denser. With more air coming into the engine from the Chrysler throttle body spacer, the computer can add more fuel to the mixture in the combustion chambers, and thus, more power is produced. The Chrysler throttle body spacer is a relatively inexpensive device that can add up to ten horsepower easily, and increase gas mileage, as well. It conforms to all of the emissions standards and is legal in all states. Our online catalog has the Chrysler throttle body spacer for many Chrysler models, and it can be ordered through our easy and secure online ordering system or with a toll-free phone call to one of our helpful associates.